Page 1 of 1
Automated Value Calculator Support Bug
Posted: January 23rd, 2015, 2:36 pm
by drm16046
The calculator only seems to work when "2 Pools" is selcted. The Value sheet shows errors when picking either CUSTOMIZE or FORCE POSITIONS.
Is there a solution?
Re: Automated Value Calculator Support Bug
Posted: January 23rd, 2015, 3:47 pm
by Todd Zola
Are you following the explicit directions for use of the CVRC?
Re: Automated Value Calculator Support Bug
Posted: January 24th, 2015, 2:03 pm
by drm16046
Yes, I believe so.
Also, catchers seem to be priced extraordinarily high on the Values page.
Re: Automated Value Calculator Support Bug
Posted: January 24th, 2015, 2:24 pm
by drm16046
My mistake, I did not do the Paste Special correctly.
Re: Automated Value Calculator Support Bug
Posted: January 24th, 2015, 2:32 pm
by Todd Zola
drm16046 wrote:Yes, I believe so.
Also, catchers seem to be priced extraordinarily high on the Values page.
I'll be writing about this once profiles are in the can (early February). The position bump is a bit greater than normal.
Re: Automated Value Calculator Support Bug
Posted: January 24th, 2015, 3:00 pm
by Todd Zola
FWIW -- apology if my reply last night seemed snooty. I was overseeing an on-line auction at the time.
Re: Automated Value Calculator Support Bug
Posted: January 26th, 2015, 8:43 am
by drm16046
I did not feel it was snooty at all!