5x5 View in Draft Mode

A board to test all the settings...
Post Reply
Message
Author
wag021970

5x5 View in Draft Mode

#1 Post by wag021970 »

10-team NL-only league, and in middle of draft. Have about 10 players per team entered, and when looking at 5x5 roto view, seeing odd stats, such as 200+ HR's for most teams, batting avg over 0.500, etc. Does average only calculate correctly once entire roster is filled? Thought I read differently in manual. FYI - seen this whether based on software pre-loaded values or CVRC. Running Windows 7. Thanks!

User avatar
Todd Zola
Hall of Famer
Posts: 8260
Joined: December 25th, 2008, 12:45 pm

Re: 5x5 View in Draft Mode

#2 Post by Todd Zola »

At this point, all bets are off - it worked properly on the version we beta-tested and originally released, then we added some what we thought were improvements and did not test it as rigorously.

This is not working out as planned but at present, our software designer is unavailable to take a look.
Catchers are like prostate exams -- comes a time where you can't put if off any longer, so you may as well get it over with and take it up the butt - The Forum Funklord

I'd rather be wrong for the right reasons than right for the wrong reasons - The Forum Funklord

Always remember, never forget, never say always or never. - The Forum Funklord

You know you have to seek therapy when you see one of your pitchers had a bad night and it takes you 15 minutes to find the team you have him on. - The Forum Funklord

Post Reply