ultrastart010112.xls

A board to test all the settings...
Post Reply
Message
Author
vpokrnut
Triple-A
Posts: 20
Joined: December 18th, 2011, 10:01 am

ultrastart010112.xls

#1 Post by vpokrnut »

I am entering the players on the hitters and pitchers tab to their respective teams with the proper coding. The rosters are correct but the standings page is not. The reliever's (R1,R2 etc) are not showing up as pitchers on the standings tab. The totals are not correct then. I changed my reliever to a P# and it showed up and totaled correctly. I am not sure what I might be doing wrong or this might be a bug.

User avatar
Todd Zola
Hall of Famer
Posts: 8261
Joined: December 25th, 2008, 12:45 pm

Re: ultrastart010112.xls

#2 Post by Todd Zola »

R stands for reserve, not relief pitcher. All pitchers should be entered as "P#".
Catchers are like prostate exams -- comes a time where you can't put if off any longer, so you may as well get it over with and take it up the butt - The Forum Funklord

I'd rather be wrong for the right reasons than right for the wrong reasons - The Forum Funklord

Always remember, never forget, never say always or never. - The Forum Funklord

You know you have to seek therapy when you see one of your pitchers had a bad night and it takes you 15 minutes to find the team you have him on. - The Forum Funklord

Post Reply